DreamForge Games Grav-Stug

I hope that everyone had a good Day of the Emperor's Ascension, and that you found all of the hidden Tyranid eggs. Don't worry if you didn't though, because whatever was in them will soon find you!

I have wanted one of these for so, so long! 

I backed both failed Kickstarters to no avail, and figured that that was that. Then I saw one of these pop up on Dwartist's Facebook page where he stated that they were being sold by Dreamforge as 3D prints in limited runs. I found one on eBay, hesitated...and it was gone. Fuck.

While it did require assembly, it was easy and quick to build.

Last week, on a whim I looked again and there one one left (this one) out of the eight originally available. 20+ people had it in their watch lists, hesitating as I had. I learned my lesson though and bought it immediately!

No vindicator is complete without a pintle mounted stormbolter (and hatch leftover from the Kratos) for point defense.

I'm thinking that this will be a prototype grav-drive Vindicator to go with my handful of Firstborn Smurfs. Sure the cannon barrel isn't obscenely over-sized in proper 40k fashion, but it ought to fairly obvious as to what the gun is. 

Not sure what these bits are supposed to be exactly...

Perhaps it's the anti-grav drive protected by spaced armor plating...

Not sure how soon it will be till I fully paint it, but I do need to paint the recessed areas under the forward side, spaced armor. Given how little they will be visible, am thinking they'll just be leadbelcher dry brushed over black.

Alternate main gun options.

Honestly the railgun/lascannon to the far left is the best looking of the main gun options, but there really is no space marine equivalent that I can think of for it. Unless of cource I put a Tau hatch on there instead of the stormbolter equipped one and use this as a counts as (Hogziliary?) Hammerhead with no burst cannons...